MODIFY GRAPHIC
It possible to modify the graphics S.V.A. intervening graphically only on the displayed curve of
the displacement.
Selecting the command will appear a pull-down menù where may be selected the option :
· Select the Basic Curve to be used into the interval of the modification, are only available
Double Harmonic and Cycloid
· May be enabled the selection of the middle point of the interval as pilot-point of the
modification
· Select which other curve must be visible (velocity, acceleration) during the modification of
the displacement.
Confirm the section pressing the key OK, indicate the two extreme point including the
modification plus the internal point that will control the interactive modification.
If no error is contained in the data it possible to drag the curves included into the selected
interval, all the curves will be moved as congruent rubber-line following the position of the
mouse.
It is possible to interrupt the procedure, in any moment, using the Break button.
To confirm the change press the left button of the mouse if the displacement must coincide with
the current position of the mouse pointer OR the right button of the mouse if it is requested a
precise value of the displacement (in this case will appear a Dialog Box in which write the precise
value of the displacement and press OK to confirm).
Note:
Redefining the Basic Curve interested by an interactive modification, the modification will be lost.
Instead it is possible to intervene on the previous and following Basic Curve.
CMM2000 Help
